wall mount stop valve angle valves float valves Be sure to keep in mind that recommended by the use of the valve is, and the application of environmental analysis in order to determine the most suitable for the installation of what kind of valve. In the correct installation of the valves before that, in order to prevent damage to the valves, valve and give full play to ensure that the work of the performance, please read the installation guide.
1. Along the first vertical pipe cutting and trimming, burr removal, surveying diameter.
2. The use of gauze or wire brush to remove pipes and cutting positions to make it shiny metal surface luminescence. Does not recommend the use of steel wool.
3. In and outside of the pipe welding mask painted with the internal flux, and flux must be completely covered by welding on the surface. Please use of a controlled flux.
4. To ensure that the valve is open. First on the heating pipes. As much as possible from the heat will be delivered to the pipeline valves. Valve to prevent the extension of its own heating time.
4a. Silver brazing:
On the need for brazing parts of the assembly. If allowed to apply the flux in a vertical components, then Flux in the water will be evaporated, and dry Flux off easily, resulting in exposure to the metal surface easily oxidized. In connection assembly, to insert a tube set of pipes until the block encountered so far. Assembly is to ensure that there is solid support, making the whole process of brazing operations can be maintained in a straight line position.
Note: For 1-inch or larger nominal path of the valves, one-time components will be connected to the heating temperature requirements more difficult. In order to maintain a large area throughout the normal temperature, usually requires two welding torch. Possession of the entire set of recommendations on the proper warm-up area. Proposed to connect parts of the acetylene flame heating. First of all, from 1-inch valves from the start of the heating pipe, and then around the pipe a short distance up and down on alternate pipeline to carry out the flames baking, and the angle of rotation in an appropriate channel to avoid burn pipeline. Flame to campaign in a row, not allowed to stop at some point.
The sleeve valve in the base to carry out the flames with baking. To heat evenly, with the flames of valves and piping to carry out the flames of the baking process to be extended to the valve on the flux is no longer sound. Do not over-heating valve.
When the liquid into a flux and pipes and valves on a semi-transparent state, the flame will start along the axis connecting parts of the advance and retreat for baking, in order to maintain connectivity components, in particular the valve sleeve parts of the base heat.
5. The use of appropriate amount of solder: If the use of solder line, then the path of nominal 3 / 4 inch valves will be used 3 / 4 inch solder, and so on. If you are using too much solder, solder some may be flowing through pipes to block the site, plug and seal the region. In connection components to install, you can see the solder and brazing alloys continue to flow
5a. Silver brazing method:
The wire or welding rod at the point where the valve seat tube sets. When the welding rod or wire to enter the junction when the flames away from the top. When the alloy flowing into the junction, before moving to the flames. To achieve the appropriate temperature, the alloy will be easier to rapidly flowing into the pipeline Shell and the space between the valve casing. Junction was filled with, you will see the edge of welding alloy.Fore more information ,please visit http://www.bossgoo.com/
